== Swiftpoint SM300 Disassembly ==
The following instructions describe the process of disassembling a Swiftpoint SM300 wireless laptop mouse.  One can be purchased [[http://www.amazon.com/Swiftpoint-SM300-Laptop-Mouse/dp/B003RSX5TK|here]].

The following video shows an example of the SM300 being disassembled.

<<Youtube(-vA3w_Y5wEo)>>

== Instructions ==

=== Remove contact pads from bottom of mouse. ===
{{attachment:wouse_build_1.jpg}}

=== Remove 2 screws ===
(1 at front, 1 at back of mouse, under contact pads)

{{attachment:wouse_build_2.jpg}}  {{attachment:wouse_build_3.jpg}}

=== Remove the top cover ===
Includes 2 buttons, lights, red grip, swiftpoint label, etc.c.  It can be pried off (note 5 plastic mechanical clips.  Start with these)

{{attachment:wouse_build_4.jpg}}

{{attachment:wouse_build_5.jpg}}

=== Unclip flexible cable from mount on the board. ===

{{attachment:wouse_build_6.jpg}} {{attachment:wouse_build_7.jpg}}

=== Remove screw near rear of mouse. ===

{{attachment:wouse_build_8.jpg}}

=== Un-solder flexible circuit at top rear. ===
Or cut away, or pull hidden portion off of inside of case.

{{attachment:wouse_build_9.jpg}}  {{attachment:wouse_build_10.jpg}}

=== Pry open clip at top of mouse. ===

{{attachment:wouse_build_11.jpg}}

=== Carefully separate frame with buttons, wheel, battery mount from base. ===
Battery is glued into slot, and wired to circuit board.

{{attachment:wouse_build_12.jpg}}

=== Pry battery free from slot. ===

{{attachment:wouse_build_13.jpg}}

=== Unsolder charging wires from plastic base. ===

{{attachment:wouse_build_14.jpg}} {{attachment:wouse_build_15.jpg}}

=== Remove plastic lens from base. ===
It is just resting in place.

{{attachment:wouse_build_16.jpg}}  {{attachment:wouse_build_17.jpg}}

=== Glue lens to bottom of circuit board ===
Place a small dot of glue on chip and lens, away from optics.

{{attachment:wouse_build_18.jpg}}

=== Finished ===